Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by niketrc

  1. N

    Global variables not initializing to proper values

    Hello My global variables are only initializing to defined values when i download my code to LPC2468. After Power reset my Global variables are initializing to random values. I am getting following warning : .\Obj\ethernet_bootloader.sct(8): warning: L6314W: No section matches pattern...
  2. N

    GSM BASED AUTOMATIC FIRE DETECTOR SAFETY SYSTEM

    Can any body tell me which type of sensor i should use to detect fire ?
  3. N

    SIM or Controller Issue

    You can send second SMS after receiving response from SIM300 , no need to keep any extra delay between them
  4. N

    How to set Local IP address in SIM900/SIM300

    Hello friends , I am working with sim900 & sim300 , is it possible to set local IP address manually ?
  5. N

    SIM900 Disable Incomming calls

    It doesn't works with my SIM300 Modem. - - - Updated - - - It doesn't works with my SIM300 Modem.
  6. N

    SIM 300 GPRS TCP-IP problem in Transperent Mode

    hello guys can anybody solve my problem ?
  7. N

    SIM 300 GPRS TCP-IP problem in Transperent Mode

    Hello , I am using two Sim 300 MODEMs for server client application.I am able to communicate in non-transparent mode, but i can not communicate in transparent mode. My Client Code >>AT+CIPMODE=1 <<OK >>AT+CGATT=1 <<OK >>AT+CSTT="www" <<OK >>AT+CGDCONT=1,"IP","www" <<OK >>AT+CDNSORIP=0...
  8. N

    SIM 300 TCP-IP problem : My server is not responding in transpernt mode

    Hello , I am using two Sim 300 MODEMs for server client application.I am able to communicate in non-transparent mode, but i can not communicate in transparent mode. My Client Code >>AT+CIPMODE=1 <<OK >>AT+CGATT=1 <<OK >>AT+CSTT="www" <<OK >>AT+CGDCONT=1,"IP","www" <<OK >>AT+CDNSORIP=0...
  9. N

    SIM300 GPRS TCP-IP Client mode problem

    I tried this code but i got CME error 6 and CME error7(on another modem), which says PH-FSIM PIN REQUIRED and PH - FSIM PUK REQUIRED . I tried to check my modem status (regarding PIN & PUK) using AT+CPIN? , modem gives READY response. What possible reasons could be for above errors ?
See more

Part and Inventory Search

Back
Top