Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am trying to make a cylindrical coordinate robot , with a grip (open and soft close functions) for 100 gr load. The arm is connected to a base that rotates 360 degrees. The arm moves as telescopic 0-10 cm, and up and down (Z
axis) 10 cm.
I am confused about my choice of motors...the more i...
verilog division
hi!!
i a writing a code in verilog which involves the use of division operator.the code works fine if i check it for syntax or for simulation purposes but gives an error if i synthesize it.it says tha division operatation cannot be done.
i f somebdy can guide me how to go...
Re: Fm/ Am
the signal is being genrated from a modulated disc.which comprises of transparent and opaque slots.at the back of the disc i have detectors.the light source is reflected via lens on to disc and you have a gyro which causes the light to be projected on to disc in a circular path.i am...
Re: delay lock loop
i have basically a narrow band fm signal.the carrier wave is of 800hz whereas the message signal is of 100hz.and i ve to demodulate it using dll.
i ve done it using pll but now i need to do it via dll.however i dont know how to proceed.
i am looking and trying to implement it.its just that i ve to start from the basics.and i couldnt really find the fundamentals anywhere regarding the fmdeodulation using dll.
thanks alot for all your help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.