Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Can someone convert the codes from 16f to 18f ? I will use these 'Frequency Counter' codes in my PIC18F452. i will be very grateful
//---------------------------------------------
// FREQUENCY COUNTER
// www.circuit-projects.com
// Y.Erol
//---------------------------------------------...
May someone create a HEX file for my PIC18F452 with this codes? i will be grateful :oops:
//ALI EMRE MENTES//
#include <p18f452.h>
#pragma config OSC = XT, PWRT = ON, WDT = OFF, LVP = OFF, DEBUG = OFF
#pragma config CP0 = OFF, CP1 = OFF, CP2 = OFF, CP3 = OFF, CPB = OFF, CPD = OFF
#pragma...
3 forward 2 back counter
I need to design between 0-9 counter circuit ( 3 forward 2 back to the counter).
Like that in order of on in 7 segment display ; 0, 3, 1, 4, 2, 5, 3, 6, 4, 7, 5, 8, 6, 9, 7
I don't have any idea. I just know i must use flip flop.
I searched in internet but i...
Thanks for all answers. They will help to me.
I havent been discovered falstad.com before. I watched your simulations and used other tools of falstad. I liked this website. thank you for your sharing with me. and youtube videos are illustrative too:)
i want to decide the numerical values of...
Hello,
I want to desing a basic dc dc buck converter. But i didn't decide about continuous conduction mode or discontinuous conduction mode. Why i must use CCM ? or DCM ? What will change if i use CCM or DCM ? Which one is more benefit for for me?
Additional question ; What i must use...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
