Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you very much to both of you...i found some interesting material on following link and it helps me a lot...it contains the schematic,board file and pdf for PCB of xbee made compatible with 2.54 mm breadboard...hope this will help lots of enthusiast...
Configuring and using XBEE...
@CKSHIVARAM
thank you very much and i am from kathmandu and it is hard to find here...it takes some time to reach here via India and but this will make hard for my project duration.
regards
---------- Post added at 21:38 ---------- Previous post was at 21:36 ----------
@ BIGDOGGURU
your...
@CKSHIVARAM
thank you very much for your help and i am very much pleased...i hope it will work...
i have another qn. too and that is i don't find that 20 pins of Xbee2 are compatible with breadboard holes. So do you have PCB diagram of it?
give me some idea.
Regards
Hello, i need to configure the Xbee and i have pair of XBee series 2 module, but i don't have Xbee explorer to configure it. I have to configure using AT89s51 uc which i have one. Please help me .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
