Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I design a ddr1 io in our chip, when I read data from memery with parallel terminations resistor the result is OK, the trace on pcb is about 6 inch(15cm),but
when I take off the parallel terminations resistance and only left the series resistor, I find I can't read right data from the memory...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.