Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
I am working with RN131G and PIC Micro controller.
I have only module of RN131G with me. I want to use its UART mode with PIC.
If i connect only RX, TX, VDD, GND pin connect to the PIC with hand solder.
Is it work properly?
Thanking you in advance.
Emerald
Have you select the Text mode for sending SMS?
unsigned char Command_CMGF[]=""AT+CMGF=1"
unsigned char Command_CMGS[]="AT+CMGS =";
unsigned char Command_CMGS1[]="+9233385xxxxx";
unsigned char msg02[]="I need your help !";
main()
{
Command_CMGF[];
0x0D //for ENTER KEY send HEX value...
From the generator mode select two SINE wave signals as a input.
Put RMS voltage 115 and -115 with 50Hz frequency.
This create your 230V AC,50Hz sign wave input signal.
Then edit properties of the transformer component.
Set coupling factor as 0.0554.
to get exact 9V for center tap transformer...
Now we are using your high print 4915 pass book printer for our applications.
Now we have a specific requirement as follows.
I want to give print command to this printer via RS-232 port through a microcontroller or say a board but not PC.
Can I give commands directly to the printer via my own...
Hi Everyone,
we have to connect i/p -> any uc -> o/p device as a printer.
IF we want to connect printer it required printer drivers.But Dot matrix printer can control by the MS-DOS.
Now The question is : Can any one suggest the uc/any intrefaceing ic which having compatibility to connect the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
