Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For future generations:
Port 2[10]/ EINT0 is also used to drive the device into ISP mode if pulled low during boot-up. The problem wac comming from radio module that was holding it low on its own power up, and since they were powered up at the same time the LPC1768 was going into ISP mode and...
[solved ]LPC1768 (cortex m3)board not working
Hi, I have built a small board with LP1768 microcontroller and powered it up - obviously something is wrong, but I can't seem to trace the problem. My question is about generic suggestions on how to solve such problems. Perhaps someone worked with...
Hi everyone, I have a problem with Ansoft designer. I need to match an amplifier on analog devices module, and all I have is the optimal impedance. The port is differential and I am a bit lost how can I model that and start doing the matching. The matching itself shouldn't be that difficult with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
