Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, sure. Here it is
I am just a beginner in learning Cadence. Hope that you could kindly help me. The pss simulation keep running without stopping.
I totally couldn't plot any 1-db compression point graph and iip3 graph as my simulation keep running without stopping.
Hi, i have designed a LNA using cadence 0.13um cmos technology with bandwidth of 4-6 GHz. My dc and sp simulation run well but my pss simulation keep terminating and show me there is an error. Can anyone please help? I have attached the related images here.
Hi all,
I have a message with 10011010100 which gives me a (15,11) hamming code of 100110100101011. However, the transmitted code is 101110000101011,where two errors are exist. Now i need to DETECT the errors but not correct them. Is there any method for detecting the double error in the...
Hi, may i know is it possible for us to detect the position of multiple errors in the Hamming code(15,11) using the method of parity bits.
Example:
The original transmitted hamming code is 100111010101111 but the received code is 111111011101111. SHOW how the parity bits indicate the position of...
Yup. I am going to build the circuit using LM741 since it is requested in the assignment question. However,may i know what is the other opamp that you would suggest to replace the LM741?
I get what you mean actually..actually that response can't be set. It come out automatically when i simulate. How to say? Actually there is nothing to be displayed on the left hand side..that range in post#5 is also not set by me..even if i set the range 100-1kHz for the bode plot, the minimum...
Hi, i have changed the swap the R#3&4. This is the bode plot i obtained.. May i know what modification should i do in order to get a proper response of a typical butterworth bandpasss filter? Thank you :)
Hi, i have tried changing the dispaly range for my circuit. Here is my new circuit.. However, i still unable to get the desired response of standard bandpass filter. I am really confusing now. Here is my bode plot . Please have a look and tell me what's wrong with my circuit. Thanks so much.
Thanks for your reply. this is the bode plot i get after modified the circuit based on what you suggested. However, it is not correct..Ain't it suppose to be like ?? Furthermore, may i know how to get the bandpass filter with gain of 2dB(as it is requested in the question).
Hi all, i am designing a Butterworth Bandpass filter to pass frequencies between 100Hz and 10kHz with a gain of 2dB using LM741. The attached figure is my design and also bode plot of my circuit in NI multisim. However, my design seems incorrect and my bode plot is totally wrong. Can anyone...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
