Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Attached my project schematic, have changed from the one given in datasheet. wonder if the value of R25, R24, R23, R26, R27, R28 or capacitors C23, C20, C26, C25 are correct.
I am using ADE7758 Energy meter Ic. In IC datasheet they given Typical Application Circuit Diagram. i followed that correctly.
In current channel section, single Rb resistor connected between the Input and GND. but somehow it cause common mode noise problem and current readings are different...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.