Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The problem was with the number of packets to be written into the Tx buffer with and without FCS enabled. With correct number of packets written, I was able to read the data without any problem at the receiver.
Thanks.
Hi,
I am attempting to transmit and receive using two ADF7242 boards. The datasheet of ADF7242 says that it has 256 bytes of dedicated RAM which constitute Tx and Rx buffers. I allocated the first 128 bytes to reception and the next 128 bytes to transmission by setting the base address for Tx...
Hi,
I am trying to transmit signals using ADF7242 at 2.4 Ghz. The chip supports IEEE 802.15.4 std. I would like to see the signal strength of the received signal and it's bandwidth. I don't have a spectrum analyzer! The next choice was to use some wifi spectrum analyzer app but wifi follows...
Hi,
The ADF7242 transceiver comes with two RF ports, one (RF port 1) for reception only and another for Tx or Rx. Port selection can be done through the register rxfe_cfg to select desired port. I would like to know if both the ports can be enable and use the transceiver in Full duplex mode...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
