Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Flyback SMPS Noise
Hi thanks for your reply..
here it is operating in DCM only.it is not going in to continuous conduction mode only..i am using quasi resonant controller UCC28600 from texas instruments...
could suggest some thing for this loop compensation.
Hi,
I designed an SMPS using fly back configuration. it's in put is 230V ac supply.out put is 24V dc and 4.2 A.
We are getting good regulation with ripple voltage of 50mV around.
but i am getting noise at different loads.we are not getting any noise at full load.but from no load to 0.5 A...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
