Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Its not difficult at all. Simply make a horn with som thickness of the walls. Then embbed copper bars of certain thickness and depth in the outer walls.Finally substract these bars from walls which will create corrugations
hfss detected an error in the acis faceting
Hi
I am trying to simulate corrugated horn antenna in HFSS. When I run the simulation, a run time error occurs in the form of the the initial mesh procedure being unsuccesful. The exact error reported is
"Initial mesh, process mesh3d : Error in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
