Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm not quite sure that power is your problem !
noise, my friend noise.. that is the problem !
on a long wires with high-speed signals you definitely will have distortion of a usb signals.
because of that your device is not recognized.
try with some usb hub in the middle in order to regenerate...
cwrasmussen,
if you need exact RC reset circuit... well
check this
**broken link removed**
about 10 years ago I had same problem ;)
anyway in this appnote intel advise reset IC to be used
good luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
