Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: sc2272-m4
Instead of this I have PT2272-M4 & I have attached it here. I have a confusion about the momentary output of PT2271-M4. What would be the actual condition I dont know. Will it give pulsating output when any data key in Tx is pressed continuously or it will give stable continuous...
Re: gsm modem error. no reply on at command: ate1
@brmadhukar: To connect the MODEM with the PC use STRAIGHT Cable & to connect the MODEM with MCU use null MODEM Cable.
Re: GSM MODEM
@brmadhukar
No need to do any thing. Open the hyper terminal.Set the settings like 8-N-1 (8 Data Bit-No Parity-1Stop Bit). Flow control none. Then go to properties & set the Baud rate to 300,600.....9600,115200 one by one and start testing. In one of the the Baud rates...
I tried to do the SMS Controller project.I used ATMEGA32 with Wavecom Supreme10 Modem & Codevision AVR Compiler. My problem is I can send AT command from MCU to PC Hyper Term & it works. I give reply typing on the hyperterminal which should be given by MODEM. Seperately Modem also works with...
Re: GSM MODEM (G2403R BY WAVECOM) INTERFACING WITH 8051 VIAR
@kumar26, Search in google By "AT Command Interface Guide.pdf" you will get what you are searching for.
Dear Yasir;
I have written the code for sending & recieving SMS with ATMEGA32 & wavecom modem in CODEVISION AVR compiler. My code does not work with Modem. Some times it work with PC Hyper terminal. Can you please find the problem?
Chip type : ATmega16
Program type ...
Dear Frndz,
I am doing a project on SMS based home automation system. I am Using Wavecom Supreme 10 Modem & ATMEGA32 MCU. I have completed my project almost. But now am facing one problem in Getting the response from the modem. I can send the AT & get OK reply.Then Send AT+CMGF=1 and get...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
