Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi there!
Well think I can help with that ... I faced this problem once, I was trying to create a copper plane associated to a specific net, and it just didn't get poured, then I realized that there was another copper pour all around the board, and I was trying to create this new copper pour...
Hi
I'm Trying to create a connector 3x6 (18 pins), i want to put 18 parts in one symbol to use the symbol like a port in the schematic, but i'm having problems to do it.
How can i create a symbol with these properties?
I'm using the DxDesigner 2007.4
Thanks,
CID
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
