Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think it is not a OS problem or any software problem,It's due to Hardware problem.
Open your CPU and clean it very carefully.Remove the RAM and Processor clean it and fix it again.
Now remove the bios battery and fix it again after cleaning it.
Now START your system to use.
If this trick not...
I faced the problem about continuesly reading the voltage and current difference ,as i used PT & CT with ZCD .I am displaying these on LCD(16x2) but i can't get continuesly varying readings ,instead of that it will give next reading when reset.
It will not affected to your laptop. But after some days the battery back up should be minimum. Therefore ,Twice or Thrice time in a week use laptop without AC adaptor connection and discharge the battery at minimum 7%.
If you install same OS but with different versions(e.g. Windows XP & Windows 7) then Hard drive memory will be shared.If you install different OS (e.g. Windows XP & Linux) then Hard drive memory will be distributed.
The speed of processing does not affect by two OS installations, because at a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
