Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Modulation is needed becuase of 3 reasons.
1.Low frequency signals are more immune to noise. So the
low frequency information signal should be mix up with high
frequency carrier to reduce noise affection
2.All sounds are with in the range from 20 Hz to 20 kHz. If
we send audio signal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
