Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
No. As I told you i am not using Arduino.
I am Using Atemga8 as Tx and RX.
the values received are OK but when I try to apply those values on PWM pins, The O/P of PWM dosent behave Properly.
Dear PEople.
I am having a problem.I am sending a stream of data from one uC ATmega8 to an other and at the receiver end I am viewing this data on my PC using FTDI chip.
The problem is the ADC values which I am sending are being correctly received on my Receier but when I try to map those ADC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
