Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I implemented the pwm and now I can smoothly break or even make a hard brake without damaging the circuit. I used the scope to monitor the voltage e adjust the pwm limits. But I just tested without load attached to the motor.
Thanks for your tips.
Hello! I'm trying to smoothly brake a three phase brushless DC motor by short circuiting the phases. At this moment an overvoltage occurs damaging the power circuit. Is this the right way to do it? Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
