Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i connect switch at RB1 and i need to send data to pc when switch off
and that my code
void main(){
portb.rb1=0;
trisb.rb1=1;
uart1_Init(9600);
do{
if (portb.rb1==1){
uart1_write("7");}
}while(1);
}
and i sure that all connections are true
i work on MikroC and Proteus
thanks for you reply but i try to convert it to Aries in ISIS but i have some problems as
1- where the pins for ground
2- where the Vcc
3- also for LEDs i don't know any one of them in library i select
finally
if any one can design the PCB and post it for me
i say for him very thanks,
i need to design pcb for led flash circuit i already design the schematic using protues but i need to know how to convert to a pcb step by step
note
i ready to use any other program if you will learn me it
here you can find the image for my schematic...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
