Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
In industrial robotic arms we can observer that servos based on BLCD motors are very popular. Why does BLCD are more popular than servos using AC motors?
Best regards
Motoman
Hi,
In my film, the piezo ignition system is far away (more than 20cm) form the LCD. Then I approached the blue wire (which is a part of the piezo ignition system) to the LCD. The image dissapeared when the blue wire was about 4-5mm from LCD's front. The piezo ignition system is not...
The test I did today.
First, the LCD was connected to a microcontroller with a signals tape. I sent graphics to the LCD. Then I disconnected the signals tape - the LCD was not connected to any circuit (power supply for the LCD was a battery). After that I did test with electromagnetic noise...
I wanted to add that electromagnetic noise does not distort the graphics (no undesired pixels appear, no pixels disappear - the image is exactly as it should be). From this it follows that interference does not affect the signals E, RS, CSA, CSB, PB0-PB7. Thus, the PCB is correct. Interference...
Hello,
I use this LCD display: http://www.artronic.com.pl/o_produkcie.php?id=684
Electromagnetic noise emitted by piezo ignition causes image disappear from the screen. Sometimes image disappears from all 3 segments (there are 3 chips, each 64x64 pixels), sometimes image disappears from one or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
