Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a Bruel&Kjaer amp, with the following data sheet:
https://www.bksv.com/pdf/Bp1702.pdf
I'm having trouble understanding the meaning of the following (within pg.12):
TRANSDUCER SENSITIVITY RANGE:
10–^-19 to 10^-–6 C/MU
(MU = mechanical units: m/s2; g, N, lb., Pa)
What does it mean...
I have a Bruel&Kjaer amp, with the following data sheet:
https://www.bksv.com/pdf/Bp1702.pdf
I'm having trouble understanding the meaning of the following (within pg.12):
TRANSDUCER SENSITIVITY RANGE:
10–^-19 to 10^-–6 C/MU
(MU = mechanical units: m/s2; g, N, lb., Pa)
What does it...
salary fund europe statistics
In Israel:
for a fresh grad:
3000-3500 Euro/month (gross)
that's 1800-2300 net.
3-6 yr exp:
3500-4500 Eu/month (gross)
(2300-2700 net)
I've got an assignment to clean a given noise signal embedded into a clean audio file.
I've attached the two wave files to this message.
any help and solution will be appreciated.
18f452 tx usart
hello!
I'm trying to write a small program that sends data using USART (through rs232).
I don't have any hardware, only using the MPLAB IDE 7.20.
In the lab at the University we have the equipment and we use HyperTerminal to see the output, I was wondering if it could be done...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.