Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ok will post it soon
- - - Updated - - -
Heres a basic circuit layout, Reed switches for inputs, LEDS for output
I have it where if one switch is connected i get the proper output, but if one or more switches are tied to it, nothing
- - - Updated - - -
If figured the code out its all done...
Ok, so hello everyone
I seem to have a problem with this project of mine.
Simple description
I'm using reed switches tied to ground, and to PORTD of my ATMEGA16
The magnet triggers more then one reed at time.
I need to be able to single out a reed switch as the greatest switch compared to...
Reference Previous Thread:
https://www.edaboard.com/threads/200935/
I'm trying to get a AT89s51 to program, I am new to this as far as programming chips...
If i construct this board for programming a AT89s51
Can i program the chip on the programmer board after being built, or do i need to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.