Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply again.
I disconnected the supply of microcontroller section only and kept the supply ON to the Triac A.C load section. This time there was no switching ON-OFF of A.C loads on making movements of plug on extension socket as opposed to as earlier observaton. So, is it ok, or...
Thanks for the input.
Yes i have make sure the 390R's are fine.
Also the Snubber n/w of resistor and capacitor is b/w A1 and A2 of Triac. I have attached the rectified diagram, I had drawn the load at wrong place in last diagram.
Plz advice, as i still face the same problem earlier
Sir, Can you please go through my circuit and suggest any modification .
/***************************************************************************************************************/
https://obrazki.elektroda.pl/5894779500_1360835298.jpg...
I am facing similar problem while controlling A.C Load using MOC3041 and Triac BTA12. Everything is fine, until when i make any movement with the plugs on the extension unit from where i have given the 230 V A.C Supply to Microcontroller as well as Load. The load gets on, even where there is no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.