Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am building a voltage mode driver for a SERDES transceiver, I am trying to run simulations using spectre to check the return loss of the driver, but normal s-parameter simulation matches to small signal impedance only, not to Ron of the device which gives me inaccurate results.
Is...
I am trying to process some data from cadence, however, the results are always inaccurate because the calculator approximates the number as the transient time increases, is there a way to stop cadence from approximating the numbers ?
Thank you
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
