Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi all,
i want to know how microstrip line is terminated by 50 ohm at the end in CST MWS...... note that the voltage source input is 1 volt as shpwn in figure
thnx in advance
hi bannay,
i want to understand the physical meaning of the boundary conditions and the cases which i set it to ( open add space) or to ( electric, magnetic, conducting wall and open )
thnx in advance
hi khaled,
the microstrip-square patch design can`t be open
also, i want to feed the microstrip itself from sma connector not the patch so, if u have a cst file designing this microstrip plz send it to me
thnx in advace
kholy
hi khaled,
this file can`t be read (( read denied))
so i ask u if u can send it again
thnx for attention
- - - Updated - - -
hi khaled,
ok plz send me this model
thnx,
kholy
hi khaled,
i have already watched this videos , but i want any CST file containing microstripline with sma coonector which already modeled (( send me compressed file))
thnx in advance ,
kholy
hi all,
iam new to cst ,and i want to know how to design microstrip line with sma connector
plz send me any pdf file to show me the work flow of this example
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
