Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Friend,
I have a pic18f8722 line follower project and I am facing a problem with writing the code in micro c
because I need to read the inputs as analogue
Thee front color sensors and three back
how can I do this in Micro C
Here are two files specifying how the whole division is expressed! with precision point to unconditional length
P.S. It may need to be much more specified but at short this would do!
- - - Updated - - -
Here is the whole division with decimal precision (the decimal point is not specified) in...
Well the principal to do this is and a sine wave with a triangle or evan a sawtooth signal the result is PWM well there is many types you must be more specific, like:
www.itu.dk/stud/speciale/segmentering/Matlab6p5/help/toolbox/powersys/pwmgenerator.html...
All General or Specialized Electronic Books have a chapter or more about Amplifiers and specifically Transister Amplifiers!
But Generally here is what I found in amazon.com:
Electronic Amplifiers and Circuit Design (Analog Electronics Series) by Bill Smith (Paperback - Sept. 25, 2009)
Buy new...
This is normal only if the load is operative i.e. if you connect a motor the load is very small and if you measure it with an ohmetter it would read less than an ohm. So if you want to connect it with a power source with a short circuit protection I persomnally have faced this situation plus...
well to solve this once and for all you can buy a car to laptop mains device it costs about $50. But you must take notice that this operation will drain the car battery so every now and then you must recharge the battery!.
I hoe that I have gave you good advice.
MNFsoft
Well you cannot just connect a capacitor and hope to solve the problem it is a very riscky solution and the UPS's output is AC so using an electrolytic capacitor is meaningless and you may damage the capacitor very easily! these capacitors are used to design DC sources only! so I think there is...
Thanks a lot PCBWING but this is the transient current I guess I will need a recording type Ammeter which I never had the chance to use or hear about until when I was studying my M.Sc.
Thanks a lot srizbf but I will give you the specifications of the A/C it is a split unit VESTEL model no. D-24...
Dear EDA board members,
How do I calculate the surge current of an A/C split unit type or window type so I can operate it using a generator, i.e. is there an equation to calculate it based on the steady state currnet? or a rule of thumb that I can use? or is it based on the BTU of the A/C? or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.