Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
So, I perform a Taylor weighting in a circular form on the array and then for the corner elements that would not be included, I just weight them lower than the outer ring?
For example of weighting, see below. Blue is the circular Taylor and black would be the self-entered corner weights...
If I need to achieve a certain SLL from a (square) planar array, I first was working a linear array of the same width. I achieved the result I wanted, but was unsure how to extend this to the planar array.
I've seen it done where the distribution was determined instead by using the largest...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.