Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by mitsubishi

  1. M

    I have problem of image processing by Matlab coding.

    Hi, yahel, Thanks for your reply. I have tried it ok. Now, I can process one imge file to sharpening. But I how to process the movie file to sharpening by Matlab. Could you help me?
  2. M

    I have problem of image processing by Matlab coding.

    sharpening in matlab Hi, Everybody, I have a project to do sharpening of image. I using the "imread" command to read a color image. then use "rgb2ycbcr" command to transfer domain to YCbCr. But I only want to "Y" signal to the Laplacian filter for enhancing edge. How to extract this "Y"...
  3. M

    Request SID paper- Driving scheme for improving color ...

    Request SID paper. Hi Everybody, I need this paper. Hope you can help. “Driving scheme for improving color performance of LCD’s: ACC”, SID’03. Ken
  4. M

    LCD Timing Controller(TCON) IP ?

    Hi ljxpjpjljx, I already pm to you.
  5. M

    LCD Timing Controller(TCON) IP ?

    Hi Everybody, Who has the TCON IP for TFT-LCD. I will exchange my existed IP to you. thx.
  6. M

    what's difference about mpeg2 v.s h.264?

    Hi anybody, I want to design the chip of h.264. so i study document now. Could anybody can point out what's difference feature in mpeg2 and h.264. On the other hand what's feature of simple profile and main profile. THX. Best regards.
  7. M

    How to implement these arithmetic operators?

    Hi everybody, How to implement logarithm and sqart root by RTL coding. I know these can use CORDIC to implementation. Anyone can provide any document or other way to implement hardware. Thanks.
  8. M

    How to glitch-free for multiple clock?

    glitch free mux Hi everybody, I have four clock (osc, osc/2, osc/4, osc/8). then i use mux to select it. but i how to avoid glitch happen? thx.
  9. M

    Why can't i use "make" command in modelsim simulat

    Dear anybody, I want to use makefile for process my design. but i can't use "make" command in modelsim simulator. My modelsim is NT version. Thx,
  10. M

    Design and Defect Testing of Wideband CMOS Op Amp

    OPA design document Reference for anybody.
  11. M

    Low power design document for ASIC

    Reference for anybody.
  12. M

    Good tutorial for verilog introduction

    Reference for anybody.
  13. M

    Basic Two-Stage Operational Amplifier Design

    OPA design Reference for anybody.
  14. M

    ESD Basic by Charvaka Duvvury

    ESD Protected Reference for anybody.
  15. M

    Schematic of watch-dog oscillator design

    Watch-dog OSC design Reference for anybody.
See more

Part and Inventory Search

Back
Top