Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks guys for the replies,
here's what Im trying to do overall.
I have a Lithium Polymer battery thats at 7.4V, 10C discharge capacity and say 1000mah. That makes it ~10A discharge / burst current.
The DC motor (MOTOR 1) is motor is 6V rated, Im running it at 7.5 V (from Lipo battery)...
Hi,
I need to run a PMDC motor rated at 6V. The stall current however is ~ 6 A. I need to run the motor using a 6V supply and draw <2A during stall. How can i achieve this ?
I need to limit the current through the motor to be <2A at stall condition.
One solution which I tried is as follows...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
