Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have interfaced CS5460 with 89v51rd2 and i am getting the rms and instantaneous values and have displayed it on my lcd. I have done the offset and gain calibration too.
Now the problem is that my rms value which i am getting is always the double of instantaneous value.
So now when differential...
I have interfaced CS5460 with 89v51rd2 and i am getting the rms and instantaneous values and have displayed it on my lcd. I have done the offset and gain calibration too.
Now the problem is that my rms value which i am getting is always the double of instantaneous value.
So now when differential...
yes sir i have done the same thing...
now i am just reading the registers.
when i read cycle count or status register or config register i am getting zero but when i am reading current channel or voltage channel gain register i am gettin 64.
what could be the reason?
Also Sir is your problem...
hello sir,
I am new to this ADC and wanted to inquire a few stuffs to you.In the SPI initialization which method have you used hardware reset or clocking sync1 and sync0 commands.Also what else has to be specified in init_spi() function.
Right now i just want to read the registers and not to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
