Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Better in the sense of its quality of working. Both seems to be used for same application (Driving MOSFET/IGBT). Cost is not a concern and i cant ask in an international forum.
Some one might facing problem with 'A' or 'B', I just want to know your experince (if you have).
MicroCon
Thanks for your interest
It is working now. The problem was config setting which doesnt allow to write while the voltage is below BOD level
Nandhakumar
Hi
I am trying to save some values to APROM on BOD interrupt.
I tried different settings to fire BOD interrupt but in vain.
Can somebody guide me through
MicroCon
Hi
I am using STM8S003K3 and trying to read adc value from channel 0.
Here is my try.
void SetupADC()
{
// ADC1_TRDL=1;
//ADC_CR1_ADON = 1; // Turn ADC on, note a second set is required to start the conversion.
ADC_CSR_CH = 0x00; // ADC on AIN4 only.
ADC_CR3_DBUF = 0...
I had diode in SOD package(Glass). No marking
It seems to be a rectifier (conclusion by circuit).
Is there any way to find out ?
Any inputs / ideas will be useful
MicroCon
Tested the circuit by Warpspeed in simulation and found working correct.
Can 5V reference replaced with voltage dividers?
Thanks klaus and Warpspeed
Microcon
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
