Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by micro_mory

  1. M

    Mounting Filter on PCB

    I experienced similar phenomenon. It is added series chip inductor(about 2nH) to connect near pad, the return loss is improved. I think ... keeping filter's high Q , matching circuit must be directly connected to filter. Best regards mory
  2. M

    Combline & Interdigital Band Pass Filter articles

    Hello all, I need more information of interdigital and combline filter. Can anyone update next papers? R. J. Wenzel, “Synthesis of Combline and Capacitively Loaded Interdigital Bandpass Filters ofArbitary Bandwidth”, IEEE Trans. MTT, vol. MTT-19,no. 8, pp. 678-686, Aug.1971. Itzhak Shapir...
  3. M

    Need MTT paper: Design of Microwave Filters (MTT vol. 50)

    Re: need MTT paper I need information of microwave filters further. Can anyone upload next IEEE paper? R. Levy and S. B. Cohn, “A history of microwave filter research, design and development,” IEEE Trans. Microwave Theory Tech., vol. MTT-32, pp. 1055–1067, Sept. 1984. thanks
  4. M

    calibration of the network analyzer

    Hello, I think this site is helpful for network analyzer. www.vnahelp.com regards
  5. M

    microstrip low pass filter

    Hi, John What bandwidth is real pass band? If pass band width is narrow, do you try band-pass filter? For same rejection value band-pass filter is small order than low-pass filter. There is combline and interdigital filter in band-pass filter. regards
  6. M

    Can we use 0603 or 0402 resistor pad at ku band ?

    Re: Ku band att pad Hi, If you can't neglect parasitic element of chip, ceramic side of chip resistor should be mounted to surface side. (resist side of chip is mounted on substrate side) This mount method is reduced parasitic element of chip resistor. good luck.
  7. M

    Fast analysis and optimization of combline filters using FEM

    Re: combline filter paper Please anyone upload above article. Best regards micro_mory
  8. M

    coupling coefficients in filter design

    ansoft filtertool If you simulate combline filter with HFSS, next article is very helpful. h**p://www.ansoft.com/hfworkshop04/2004_HFSS_Users_Workshop_Douglas_Dawson.pdf
  9. M

    Fast analysis and optimization of combline filters using FEM

    combline filter paper Hello all, I need the following paper. Can someone upload? D. G. Swanson, Jr. and R. J. Wenzel, “Fast analysis and optimization of combline filters using FEM,” in IEEE MTT-S Int. Microwave Symp. Dig., May 2001, pp. 1159–1162. micro_mory
See more

Part and Inventory Search

Back
Top