Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i draw a rectangular (sheet) in HFSS and define it as lumped port excitation and characteristic impedance of 50 ohm, but after the simulation and plotting port Z0 for Z0(p1) and Z0(p2) in rectangular plot section of results, i saw a characteristic impedance of 34 ohm, not 50 ohm.
i think i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
