Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi i need to help;
My desing is fail in burst and surge test.
my circuit.
**broken link removed**
so my circuit is fail.
my controller is pic12f629.
the microprocessor circuit directly into the ground line is. To insulate the soil line so I connected coils. But this was not enough. As you...
hi, i have a problem about sea communication.
as show in figure, i want to make communication between two antennas. First antenna is over the sea, second antenna is over land or sea. between range of two antennas is 5 km.
according to you. Which frequency band can I use? Which is the best ?
hi, i have a problem about sea communication.
as show in figure, i want to make communication between two antennas. First antenna is over the sea, second antenna is over land or sea. between range of two antenna is 5 km.
according to you. Which frequency band can I use? Which is the best ?
need to gsm modem
hi everyone
i need to gsm modem. i will use it my home securty project. it must run Full At command. For examples, i used ericsson t10s for this project. But this equipment has bad mounting structure. where is it to buy and home site.
gsm+pic+at+command+ccs
Hi;
i want to send at command my gsm mobile with pic 16f628.
For Example;
i maked test below code with hyper terminal. Everything ok.
------------------
at<Press Enter>
OK
atd0498xxxxxxx<Press Enter>
------------------
it is ok who maked with the example.
NOW.
i want...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
