Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Off the shelf buck converter? Do you mean an specific IC that performs as a buck converter like the LTC3112? I would, but I was asked not to use a specific IC that performs in that way, and rather build it using passive components (i.e. with an inductor, capacitor) and a MOSFET and diode. Also...
I'm designing a switched-mode power supply (SMPS) buck converter which can step down 35 V to a specified value below. The output is fed back through a voltage divider which maps a maximum 35 V to 5 V into the analog channel of a PIC16F877A microcontroller. The MCU has the PID control loop...
Good evening everybody. This is my first post here.
The thing is that I'm trying to simulate a buck DC-DC converter using a IR2112 MOSFET driver, two IRF530 n-channel power MOSFETs, and several other components as shown in the picture attached below. As the control signal, I'm simulating the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
