Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
dear ederelk & goodgood,
i dont know if u set the proram to read from rs232. if u do, then u must have kbhit or anything similar to detect the incoming character frm rs232. then u must read from rs232 to extract the data from the modem. then u need to segregate the data or just extract the...
Re: faults in gsm modem pic
"Firstly, connect it to the GND then connect it to 12V. The module will response for your command"
u did it manually or with PIC programming?
---------- Post added at 02:53 ---------- Previous post was at 02:51 ----------
kemystri, your connection on Rx and...
the best build pcb
I wrote something about this topic in my blog about my own opinion & experiences using a few software like Protel99SE, Proteus, Orcad, etc. check out the following:
https://hi-training.blogspot.com/
Go to July Archive, you'll find this same topic. I'm in the search for the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.