Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: 3 phase to DC converter
I am using IGBT module (3 phase Rectifier bridge + 6 transistors)
Not using switching mode
As you said - I am going to design flyback DC\DC converter
My first thought was to take one phase and neutral because most of the design (for flyback converter) that I saw...
Hello,
Working on design - inverter for 3 phase induced motor 380VAC x 3
I am using IGBT module (rectifier + 6 transistor) that convert the 3 phase to ~537.4VDC = 380 x 1.414
I need from that voltage 537.4VDC create lower voltage for the control section - 15V + 3.3V Isolated
one option is to...
Hello
I have a circuit that control on a 24VAC for a load
the problem is short circuit on those lines - my triac(8A) burnd
and I have fuse(5A) on my 24VAC source
How can I protect the line without using fuse\resettable fuse ?
The schematic -
Many thanks,
Mayer
Hello
I working on a tracking device That send GPS cordination.
The device Send GPRS message in rate of 30 Sec
The device works about a week and some how it stop working
My watch dog tries to activate the modem again with no success
How can I monitor modem status ?
Thanks,
Mayer
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
