Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: how to control the 8 wired stepper motor by using the GP
Hi Nandhu,
thanks for reply..
may i request the circuit construct for the 8 wires stepper motor and the uln 2003??
Regards
max.
Hi all,
i doing a project which is control the stepper motor by using GPIO.
but i felt confuse between the 6 wired and 8 wired stepper motor,are they can be using same method to control??
and also can i use the IC uln2003 to control the motor???
thanks for reply betwixt.
u mean that i can directly control the stepper motor by using driver uln 2003 with GPIO pins.then can i contruct the uln 2003 and stepper motor circuit which shown below to operate the motor?
Hi all,
I need sincere advice.
I have a project in which i have to control a 6 wire unipolar stepper motor.
Stepper motor will be controlled by GPIO for rotating an antenna. It is posible to use IC 74ls244 and uln 2003 to operate the stepper motor, and how??
pls give me some sugestion,thx..
Hi all,
I need sincere advice.
I have a project in which i have to control a 8 wire stepper motor.
Stepper motor will be controlled by GPIO for rotating an antenna. Can i using the IC ULN 2003 as a driver to control the stepper motor?
Can somebody suggest a 8 wire motor controller circuit by...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
