Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, without any problem.
---------- Post added at 22:01 ---------- Previous post was at 21:24 ----------
If I set it to route the net 'GND' only in bottom layer, it works properly. I'm confused.
Thanks Zula.
I'm sorry I wasn't clear enough. Those were two different attemps.
U1 is already included in Bottom class.
Just in case, I tried your suggestion but it didn't work.
---------- Post added at 15:50 ---------- Previous post was at 15:50 ----------
Let me show you with a picture...
Hello, I'm new in this comunity and I need some help.
I want to set a rule to avoid the autorouting using the top layer in some components.
I've tried with the querys:
InComponent('U1')
and
InComponentClass('Bottom')
But neither of them worked.
Any suggestion?
Thx a lot.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.