Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Done, mesures infinite. Means dead. When i removed it carefully tha side contact come off and i can see 3 little wire ends in the package under the microscope. I have see the burn marks and measuring contacts no damage to leads.How can i overpaint the burned off lacquer to make proper insulation...
I have found it on the schematics. On the relay PDF called VT2 on the second page type ON Semiconductor BCP 56. And the part must be the resistor with the value 180E. What the hell is 180E?Does it makes sense?
On the schematics i cannot find it. It is a car diagnostics multiplexer the analogue side. on board when i measured it it was 205 Ohms.Schematics attached.
I have looked thoroughly but no use.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
