Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi, everyone,
I want to simulate the third-order synchronous generator, but I don't know how to set initial conditions:
1- delta (angle of d-axis ahead of a-axis)
2- e'q (transient internal voltage of armature)
3- Tm (mechanical torque)
Please, I need help, thanks
Dear all;
i have tow questions:
I)what is the relation between surface current and isolation of patch antenna?
II)the current surface is better when it is low or high?
anyone can help me
thanks
dear all
in the following figure, anyone tell me why is the measured S11 larger than the simulated one in low frequency but smaller than the simulated one in the high frequency
Dear All
i have data from an expremental mesure of a patch antenna (txt file).ther are lots informations in this file, please how can i plot 2D radiation pattern(E-plane and H-plane) in matlab or origin.
Thank you
Dear All,
I have simulated a patch antenna using CST 2014 the result gave me very good BW and radiation pattern, from here i am new and i have no idea how to start the fabrication, my question is how to layout the simulted patch antenna?
Thank you
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.