Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by masri

  1. M

    What does the variance mean for the RV?

    Re: variance variance is the ac power of the signal and the root of it gives thestd deviation
  2. M

    Why QPSK is used in CDMA?

    Re: QPSK in CDMA? beacause of the simplicity of the modelator and demodelator and its reasonable bw
  3. M

    what is significance if rms voltage/current

    significance rms value rms value is the equivalent dc value of an ac quantity
  4. M

    Which book is best suited for studying digital electronics?

    digital fundamentals by malvino and leech neamen and bougart
  5. M

    DIGITAL COMMUNICATION TRANSMITTER AND RX PROJECT(WANTED)

    I NEED A SCHEMATIC FOR DIGITAL COMMUNICATION TRANSMITTER AND RECEIVER WHICH IS NOT SO HARD TO BUILD AND CAN BE BUILD FROM AVAILABLE IC'S AND ELEMENT I NEED TO BUILD THIS PROJECT FOR MY GRADUATION PROJECT
  6. M

    Which one is better for audio: ICL8038 or MAX038?

    xr2206 single chip function generator MAX O38 IS BETTER FOE HIGH FREQUENCY
  7. M

    Spectrum Analyser Manual

    it gives you fast fourier transform and informations ABOUT THE FREQUENCY CONTENTS OF THE TIME SIGNAL CHEK ALSO www.agilent.com
  8. M

    Need Help: PLL for 50 Hz

    you can use pll ic or a flip flop this will not be affected by the low frequency
  9. M

    Why do we need negative voltage?

    Re: Why we need V-Negative? need negative because the free charges in the electrical current is the free electrons while protons stay fixed in their positions current flow from high to low voltage op amp output varing bet:ween +vcc and -vcc if you havent negative the -ve portion of the output...
  10. M

    what's the function of this circuit?

    it belongs to digiotal electronics cmos circuit
  11. M

    How to deal with DC offset and replace it by AC-signal

    hi hi to solve the offset problem you have to use a cpacitor if you want to just pass the positive portion of your signal you have to use half wave diode rectifier:idea:
  12. M

    Two questions about CB transisters

    Re: transisters hi i havent understanded your question well but this topic is clearly demonstrated in twoo usefull books 1_electronic devices( author bolysted) 2_electronic devices and circuits (neamen) 8O
See more

Part and Inventory Search

Back
Top