Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by maryam.ha81

  1. M

    Short Dipole HFSS 1 port or 2 ports

    dipole.hfss that is because the efficiency of short dipole is very low witch depends on it's short length(l/lambda). that is why the gain of a short dipole is very low even though the matching network is perfrct. but i think your approch is not the rigth one. because for a short dipole (and...
  2. M

    Microstrip Antenna Gain Equations

    e is the efficiency of the antenna; E=(Rr./(Rr+Rd)); Rr= Radiation Restance Rd=disspation Resistance Rr is calculated by: (Rr=Vin./Iin) The FR4 is specially for the low frequencis applications and for the higher frequencies it's loss becomes dominant. it can be used up to 1-1.5GHz. for the...
  3. M

    Microstrip Antenna Gain Equations

    the genaral relation as you know is "G=e.(2*pi/lambda).Ae". "e" is the efficiency of the antenna and "Ae" for microstrip patch is the physical surface of the patch. "e" depends on the input impedance and input impedance depends on the feed point. i don't know any link for HFSS but I can upload...
  4. M

    What are the rules for RF layout (20MHz to 2GHz) in ADS?

    RF layout in ADS thanks for your answers but i also need to know that if the back side ground plane in all cases is necessary or not. because of my special application, i need to use the other side for placing the elements and microstrip lines so i can't definea back-Ground plane.Is this a...
  5. M

    What are the rules for RF layout (20MHz to 2GHz) in ADS?

    RF layout in ADS Hi I want to draw a preamplifier layot in ADS. i want to know the special rules for RF layout design in(20MHz up to 2 GHz). in this frequency range the GNDvias are needed or not and if yes where should i insert them? and in ADS how i can change an orbitaray metal shape to a...
  6. M

    Microstrip Antenna Gain Equations

    hi in general case there is not any theorical formula for that but for rectangular and triangular structures there are some formulas that you can easily find in every "Antenna" book and i sugest you the Antenna dook by "baul". you can find anything you want to know about micristrip patch...

Part and Inventory Search

Back
Top