Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi unipolar motors are easy to drive the center taps of the coils go to the supply voltage. the coils can then be pulled to GND using a FET. you will need 4 FET's in total one for each coil. Don't for get to add diodes across the cols to help with back EMF from the switching. If you need more...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
