Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Does anyone know how to create the symbol for a Gate that doesn't start at pin 1? I am looking in the "PCAD Lib Exec User Guide, page 86, and it shows the 4 symbols used in a SN54HC7404. These symbols do not have sequential pin numbers that start at 1. The tutorial claims that these were...
F+ and F- are the output of the MAX9737 Eval board. I have attached the schematic. This problem shows up only with light loads. If I put the 8Ω load on the output of the Eval board, it looks fine (other than a little 300kHz remnant of the class d switching). I have not checked with loads...
Hi,
I am trying to use a Class D Amp to drive a non-audio application (360 - 12000Hz, load will vary), and am getting distortion on the output when no load or lighter load is present. The basic flow is:
Class D Amp -> LPF -> Step Up Xfmr -> Output
I am using the LPF in the Eval kit...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.