Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
The solution is: the circuit always have to draw current.
Try put a driver with 2 FETs
See a microchip driver TC4422
Need more current? Change source voltage.
Good luck! :)
Re: lattice isplsi
What do you really need?
There are free tools from Lattice like ispLEVER. You can use VERILOG or VHDL to do logic.
Try Lattice support. They are very efficient and fast
techsupport@latticesemi.com
realtek change mac address eeprom windows or dos
In Windows 2000 and XP you can change in properties hardware card
Works in Realtek one. Advanced/Network Address
Good look
Marcosax
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.