Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello this is manjunath
I had a problem which i cannot solved but i try it in many ways in proteus software the problem is that i'm using comparator for comparing two voltage while the comparator is connected to the micro-controller while doing simulation it is showing "PIN '1' DOES NOT EXIST...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.