Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Manjuladevi

  1. M

    Spiral inductor response

    Hi all, I have simulated the spiral inductors in cadence. I was very new to this theory. Can you please guide me .Is this correct plot for the L and Q values for the observed response. And kindly give the brief explanation about the abserved response.
  2. M

    [SOLVED] why dip come on elevation pattern?

    Hi, I have got measured radiation patterns for 3.3-4.2G Omni antenna. Im giving 3Elements with .83lambda spacing between each dipole. why this main lobe dip came ? Kindly help me.
  3. M

    [SOLVED] power divider for 5G

    Thank you..I have introduced DC Gnd for matching.
  4. M

    [SOLVED] power divider for 5G

    I'm designed but im getting tolerance varied up to 1dB 1633344156 im having the spec which is up to 26 x 13mm in dimensions.
  5. M

    [SOLVED] power divider for 5G

    5.1-5.9GHz 1632995133 Can You able to design? Would you clearly read my ques? I have already stated my working freq band 1632995288 Fine, Thanks for your reply.
  6. M

    [SOLVED] power divider for 5G

    Hi all, I want to design 1:3 5g equal power splitter for my antenna applications. In that I'm getting 1db step difference between every arm.Im giving 33.3% power for all ports. and also I'm using L bend division network. Please help me I need to complete it.
  7. M

    [SOLVED] How to calculate phase and magnitude for each

    Hi Im manjuladevi, Im a researcher on RF and Microwave. Here, I have tested 1:2 equal power divider.I want to compare measured and simulated datas. I want to plot it through excel. so, what is the formula to calculate phase and mag? This is the snap shot that i was attached below:
  8. M

    [SOLVED] losses in microstrip line

    Directly i'm taking s2p plots mapped to xcel and make it as a comparison from 500M to 2.5G
  9. M

    [SOLVED] losses in microstrip line

    how traces related with width..width is mainly depend on impedance but traces are not like that
  10. M

    [SOLVED] losses in microstrip line

    I have compared S21 from simulated and measured from VNA
  11. M

    [SOLVED] losses in microstrip line

    HI all, I'm a researcher, i'm getting an error, when i was simulate 100 mm,er-2.55,-50 ohm transmission line from (500 Mhz to 6 GHz), im getting an insertion loss for 2.5 GHz will be -0.1 dB but practically i haven't getting that result. I got -0.35 db. what is the loss behind in it, and also i...
  12. M

    Design confromal antenna using hss with matching network

    Hello, i just want some help to run simulation.. If bond wire will helpful for probe connection between matching network and antenna. how can i bend the whole entire surfaces(gnd,substrate,patch)
See more

Part and Inventory Search

Back
Top