Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am doing some measurement using a 8way equal split power divider. But I am using only 5 output ports out of 8. The remaining 3 port are terminated with load. After the measurement, I need to compensate back the loss from the power divider. The loss that I compensate back is it the same...
Have tried using the highest dielectric substrate, it is still consider quite long.
---------- Post added at 09:29 ---------- Previous post was at 09:27 ----------
Thk... I will try using this method. :)
Hi,
I need help in shortening the length of the microstrip line.
Supposingly I need to have a microstrip line which give me a 8ns of delay in the 300MHz frequency. Then I will need to have a very long microstrip line to obtain that.
Any ways or methods that I could use to shorten the length...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
